DIY Toys R Us

[les]

There has just been a thread on a "Duct Tape Chatity"
http://www.milovana.com/forum/viewtopic.php?f=1&t=5750

This has made me think.

One of my toys is a
"Jubilee Clip Cock Ring"

What I have done is to wrap a piece of velvet ribbon around a jubilee clip to make a very lightly padded "Doughnut" just enough to prevent cuts from the edges.

Now the clip can be put on my cock and the clip tightened to any size,
It can be so tight absolutely no cum is released at all.

Then when finished the clip can be loosened and easily removed,
Without out any fear of a "Too Tight/Small Ring" requiring a hospital/doctor trip to have it removed.

[foleyflint]

cool idea.
I'll try this next week.. can't wait.

I am just wondering; is it dangerous to tie your balls off that tight, no cum is released? Or does it do no harm?

[les]

I use this on my cock above the balls


Les

[foleyflint]

okay, understood. does that mean that when you take it off after an 'orgasm' the cum comes oozing out?

[cumhardy]

I once made a cock-electrocuting device from a joke electrocuting lighter like the one below

lighter.jpg (2.14 KiB) Viewed 3353 times

Just attach 2 wires at the metal contact points and make loops of bare metal wire at the ends. One loop goes round the base of your cock, the other loop goes at the cock head.

lighter2.jpg (8.42 KiB) Viewed 3353 times

When you push the lighter button, the current passes through your cock. You can tape the button down to get a continuous current.
Sometimes I've even added a little potentiometer to one of the wires to control the voltage levels.

[les]

okay, understood. does that mean that when you take it off after an 'orgasm' the cum comes oozing out?

Yep

cumhardy

Can not figure continuous current as the spark is caused by "piezoelectric" effect,
ie hitting a crystal.
That's why the lighter clicks.


Les

[cumhardy]

^^^^ It is not a real lighter, its is a practical joke powered by a battery. It electrocutes peoples hands with a mild electric shock when they push the button.
http://www.paramountzone.com/shocklighter.htm
There is metal at the bottom and the push-button is metal. Usually a victims hand connects the circuit and they are shocked.

Looking at this
http://rimstar.org/materials/piezo/ignitor1.htm
it looks like a piezoelectric ignitier could be removed and used to administer very small shocks too.

[les]

^^^^ It is not a real lighter, its is a practical joke powered by a battery. It electrocutes peoples hands with a mild electric shock when they push the button.
http://www.paramountzone.com/shocklighter.htm
There is metal at the bottom and the push-button is metal. Usually a victims hand connects the circuit and they are shocked.

Looking at this
http://rimstar.org/materials/piezo/ignitor1.htm
it looks like a piezoelectric ignitier could be removed and used to administer very small shocks too.

Understanding dawns
A wicked glimmer flickers in thought.

OOOH

Les

[les]

Kitten O Nine Tails
My Kitten has claws!

Right parts needed 6 to 9 feet /2 to 3 metres
Nylon cord/Parachute cord.
10 large cable ties
1 foot/600mm duct tape.
A flame
I used a cheffy blow torch.

Now wrap the cord four and a half times around your hand
Tease the loops until all is even with one end up and one down.
Use one cable tie to secure the bundle at one end.
Carefully cut the four long loops evenly.
Trim if needed
With the flame gently seal the nine lengths with the flame
Be careful molten nylon sticks better than wax and is far hotter,
The pain is yet to come.
At the ends secure a cable tie
The reason for selling the ends is so the ties do not slip off while tightening.
Tighten each tie twice.
I then re melted the cord so welding the clips on.
Allow to cool.
Try on you arm
Now use cut lengths of gaffer tape to create a handle about four inches 10 cms

I found the pain much “brighter” than a ruler or paddle.

les
also in picture jubilee clip cock ring

[dr.d]

years ago I took four medium sized dog collars, four luggage locks and two ten inch chains and made wrist and ankle restraints. punch a small hole in three of the collars thread the lock through the hole you made and one of the other holes in the collar add a link from the chain and close the lock . you should have the collar locked around your wrist or ankle. the last collar is your emergency release, buckle it around your wrist without locking it on. just lock the chain to the D-ring on the collar.

[les]

Get a length of soft rope tie a loop end on each end for your wrists.
Throw the rope over and behind yo

[les]

I thought I would link these two threads





................................................. Les