Prevent slipping out

[atatflo]

Hey,

do you know any possibilitys to prevent slipping out of the chastity-belt? If I stand up, it slips down and if i help with my hands, I'm able to slip it over my whole cock. If I take a smaller ring size, my balls turn blue and start to hurt.. Would a larger ring help, so that I could wear it a bit higher?
It doesn't matter, if it slips a bit, but I don't want to be able to pull it out completely. Do you have an idea for a self-made tool or something?
Hope, that you can help me...

[SexualChoc]

first what kind of chastity belt?
There is some things you can do depending on what kind it is.

But I need to know that first.

what ring size do your ball NOT turn blue? what is "comfortable?


So it just slips out while standing? Is this standing for long periods of time?
I have actually experienced that with one of my chastity belts
so I think I may be able to elp

Are you able/open to buying a different one?

[atatflo]

This one is my chastity-belt. I already bought 2 different ones, but the CB6000 was much too small.

The ring-size is 4.5cm, that's 1.77 inches. It slips down the moment I stand up.

Thanks for your help! :)

[SexualChoc]

hmmm
I don't see any obvious design flaws with the ring
if you need a bigger cage, I don't think you would have the physical differnece of having "small" balls
which causes slipping


here are some ideas
perhaps the problem is the metal?
>idea (1) try wrapping the base ring with some tape to make it a little more "grip" I would not recomend a thick layer just enough to create some "friction:
so as to not cause problems I recommend buying surgical tape at a drug store
is very in-expensive
and just experiment I would do some "wrapping on the bottom part of the ring

idea 2
make it a full chastity belt
not just a cage
http://www.spicesforlove.com/images/Mal ... belt-j.jpg
attach the cage around your waists using some kind of belt

Idea 3
this may be the best of the three but leaving the other two .
I personally own a metal cage the Nice thing about metal is it very difficult to break you can BEND IT!
on of may cages was a tiny bit tight I used a screw driver to "pry: it open
just "close" the gap a little where balls are so bend the ring up or tube won, just strong constant pressure of using both you hands might do it depending on metal tolerances, if not you may want to "tap" it lightly with a hammer, have the cage fully assembled, lock and all for adjusting if you go to "squeezed" use a screw driver to "open" again.
you should be fine bending it a little


the problem is that the weight, gravity of the cage is more than the friction force of keeping it on
and you slipping out. hopefully one of the suggestions will work or help youu thing in a direction that does.