Thanks m8! The question was rather rhetorical in nature.
Based on your last post, I had already re-checked the FOC Github project and saw that V4 must've been released just after I ordered the parts for V1. Down the rabbit hole I went, where I found the 3D files for the sensor, hence my remark about having to get into 3D printing, too. I'll probably be happy with my V1 for the foreseeable future, but it's great to see that there is already something very promising beyond it, should I ever get bored of V1. Again, a huge THANK YOU to everyone who is putting time and effort into this stuff, including you! I wish I had the time and more talent to contribute in some way too, but apart from some minor stuff a while back, it's just not in the cards for me at the moment.Also, thanks for your suggestions regarding the Restim settings, I'll definitely try that! The electrodes and their positioning I can pretty much rule out as an issue, they are the result of many years of experimentation and improvement and get the job done every time with perfect reliability (both with Stereo and FOC-stim), given the right signal. It's definitely a matter of personal preference. FOC-scripts mostly just don't quite hit the spot for me out of the box, and I believe it's a frequency thing. I'll report back some time, but don't hold your breath, it may take me a while.
