SkyLigth wrote: Thu Jan 08, 2026 10:22 am empornium is not down, they change their domain to .sx now.

Ah, good to know, thanks.

Not to pile on, but I'd also be interested since it appears Empornium may be down.

I plugged ST's Board Design project files into Altium's online viewer for you:


Screenshot_20250131_184111.png

That's a top-down view, with USB in the bottom left.



Got it swapped out, but that diagram seems to be backwards. I compared it against the installed pot about six different ways ...

I plugged ST's Board Design project files into Altium's online viewer for you:


Screenshot_20250131_184111.png

That's a top-down view, with USB in the bottom left.

Hope that helps. As long as you get the wiper (pin 2) right, worst that can happen is volume increasing when you turn CCW ...

Has anyone tried removing the potentiometer from the ST board and wiring in an external one? If so, can you show how you have it wired - I'm interested in doing that, but I'm not sure which pin on the pot goes to which pin on the board.

However.

I'm totally lost on what to do now. I thought I might be able to figure it out intuitively but I'm sorry I'll need some more ELI5 instructions if anyone can provide them? The software STM32Cube programmer looks nothing like the screen shot on diglet's github.

Many thanks


The ...

Ok, did some more playing around and edited this for my new issue. I can get restim to connect to the board successfully on COM3, but I can't also get teleplot to show anything. If I try to connect teleplot with restim already connected I get an access denied error and vice versa (I assume because ...

Just getting started with Restim - had it configured with MPV and MFP and then realized that is no longer really needed so thanks for making things simpler. Question I had though, maybe I missed it somewhere, but is it possible to configure a different folder location for the Funscripts from the ...

Looking at the Popstim Edition Estim (Smooth Ramp) file, I can see that it uses several different frequencies. Looks like 600Hz, 1000Hz and 2400Hz. Especially if you have a DIY box without parallel resistors, going down in carrier frequency feels like an increase in intensity. Before I added those ...

Anyone else have a problem with the levels of the estim file? I think the signals are really good, and I like the variation, but it seems like some sections are significantly louder than others, making it hard to enjoy because I have to keep one hand on the volume control. DIY stereostim box.

ilMerolaMario wrote: Fri Jul 07, 2023 3:23 pm Hello!
I am quite curious about this project, could you send me the link for the alpha test version?
Thank you!!

Likewise for me. Thanks.

What output is everyone using on the new T7010 transformers that have the 1W, 0.5W, and 0.25W leads? The yellow 1W one?

Is it possible to use pots to control the signal output for each channel? I was wondering if inserting them after the transformers would allow me to control L and R output strengths?


There are designs for that, between the input and the amplifier. If you search for Bonnie Volume Control, that's ...

Thanks for the feedback. Ended up ordering a pack of isolated stereo plugs to use for the input and output jacks. I'll probably keep looking for a plastic case also.

Anyone have any thoughts or info on a case to use for a DIY box? I've had one I've used for quite a while, but it was just kind of lying free in a cardboard box, not mounted in a case, and recently I used a metal box I had laying around to mount everything. It seemed to work okay in normal ...