Milovana.com

19Hellothere83 wrote: Thu Apr 07, 2022 11:24 am
I also ordered this one:
https://www.amazon.de/gp/product/B09BNN ... UTF8&psc=1
this has a lot of power ... however it will not work with a funscript probably ... since you don't know the position of the motor?

hosenguy wrote: Sat Apr 09, 2022 3:36 am I have been thinking about a similar device except I want to drive the diaphragm on the V2K. I have discovered a few issues to cause you pain in the brain.

Hardware. The motor in you first link will not start and stop quickly enough for real use. You could add a brake to stop it but it stills has to build up speed at the start.
Digital motors can get around some of this and I find information here and there about this. I currently am not ready to post a link. These type motors are more expensive by fare, and require special driver electronics to match.

Software. Until the Handy and the OSR by Tempest Max cam along there was very few apps that could play vids and provide time info to allow the scripts to sync. That is very much changed with the OSR and its T-code driver. This driver is mostly for servos but it is open source and he even teaches in a webcast how it works. To drive a motor you would just replace a bit of code and use most of the software.

Unfortunately I have not gotten any further than you with a working design.

Be sure to keep this thread up to date. Please. I will alswo post if I get a working machine.

edger477 wrote: Sat Apr 09, 2022 8:20 am

19Hellothere83 wrote: Thu Apr 07, 2022 11:24 am
I also ordered this one:
https://www.amazon.de/gp/product/B09BNN ... UTF8&psc=1
this has a lot of power ... however it will not work with a funscript probably ... since you don't know the position of the motor?

I can only tell you that you can't make this one work with funscript.

Funscript describes position of the device (dildo/fleshlight/whatever) over time, and for that it requires a special motor, called "stepper motor", type of which is used on CNC devices and 3D printers (because software can receive exact number of rotations = exact position of the actuator). Stepper motor with enough power to drive fucking machine would already cost as much as this whole device, and you need electronics to control it, software, and mechanics to convert its movement into actuator.

cfs6t08p wrote: Sat Apr 09, 2022 9:29 pm If you're willing to DIY, check out OSSM: https://github.com/KinkyMakers/OSSM-hardware

There are some commercial devices that could do it but I don't know that the software exists to make it happen, not to mention they're crazy expensive, machines like the Shockspot and Hugher Tango come to mind.

There's also the Fredorch F8 which is substantially cheaper https://www.aliexpress.com/item/1005003173701515.html but I would be more than a little concerned about the capabilities and build quality of this one.

alexjackman wrote: Sat Apr 23, 2022 8:01 pm Going to try a build of something like this myself. Parts are on order but won't see all of them for almost a month. Once I've received them and had some time to have some success, I'll report back!

cfs6t08p wrote: Sun May 29, 2022 6:44 pm Since posting in this thread I have built myself a machine similar in concept to the OSSM but designed to handle larger toys, it's been an absolute blast so far

Those vibration scripts people have been putting out for the Handy offer quite an experience