Milovana.com

Here's a DIY anal electrode for estim based on an older version of the Aneros MGX Trident.

• The construction is done with 1/4" or 6mm copper tape, smoothed out as best you can.
• The edges are sealed with clear nail polish.
• Nail polish is also used to insulate the lower visible half of the copper strip.
• Then it's mildly sanded with fine 400 grit wet or dry sandpaper to make sure there are no rough edges.
• It should feel completely smooth.
• The electrical connection is two wraps of bare copper wire wrapped around the foil base, hot glued and taped. I didn't feel the need to solder that connection.
• I have some hot glue on the tabs to make them a little larger and more comfortable for me.

Do you like it ?

Bluemoon wrote: Mon Nov 22, 2021 3:57 pm Do you like it ?

It worked very well. The Aneros is the right size and shape, unlike a lot of commercially available estim toys.

I agree and love the aneros range of toys I'm very curious about the combination with estim ...
This is a mod I want to do since a long time, I would appreciate your detailed feedback about the sensations !

tip for smoothing metallic tape - use a hard, round item like the shaft of a screwdriver to run over the edges and burnish them before any sanding.

The ElectraStim Habanero has a pretty great shape for prostate massage, but its contact points are along the sides. I built one of these with a Progasm, but it ended up not that comfortable to sit on, longer-term.

That's a really good job. well thought out and finished. Excellent.

Bluemoon wrote: Tue Nov 23, 2021 10:12 am I agree and love the aneros range of toys I'm very curious about the combination with estim ...
This is a mod I want to do since a long time, I would appreciate your detailed feedback about the sensations !

It's hard to describe but it combines the prostate stimulation of the Aneros and the prostate contractions of estim.