Milovana.com

Any reccomended step by step guide for cock and balls tie? Any kinky suggestions to spice this kink up? New to this

I did two teases way back in our "beginning days" that have detailed written tying directions, especially the second one, if that helps.
Just check my teases. The only two i completed.

Usually when I tie my cock and balls I use the Jury mast know, its simple and provides adjustable tightness. there are plenty of tutorials on tying the knot and they are way better at explaining it than I would, but Ill show you how I apply it to my junk

The final knot should look like this

Spoiler: show

place your balls in the middle hole and your cock through the top hole. Then pull the sides and the top to get the desired tightness for the balls then use the bottom strings to adjust the size of the loops. You could leave it here once you are happy but I tend to put the side loops around my balls as well to not have as much loose strings. Then you can tie off the ends if you want but the knot should hold through friction alone. getting it just right can be a bit tricky at first but once you've done it a couple times it'll be as a fast as tying your shoe

Huh, interesting. I never thought about using something like the masthead (jury mast) knot for this. I don't see why it wouldn't work.

A somewhat similar knot which could also work is the jug sling. It will generally be more secure than the masthead, but that means it takes a bit more doing to loosen it up as well, so always be careful of course. The jug sling has a bunch of ways to tie it, but I find the easiest is this:

Spoiler: show

But for bondage like this I usually like to use a simple cow hitch as a base to start from. In this case, you would take your line and fold it in half. Wrap the doubled over line around your balls once. This should leave you with a looped end and an end with two ends. Pass the ends through the loop and pull to however tight you want it.

From there you can get as creative as you like to secure the hitch. I would pull it tie, split the ends so you can wrap them around the base of your cock and then tie it off with any knot you feel is secure enough and easy enough to get out of. You can always add more wraps if you want a thicker tie somewhere, just take care not to pull it all too tight.

In general for bondage I like to try and keep the knots simple (or slipped) and use multiple wraps for security, since it's quicker and easier to get out of bondage if the need arises. Figure 8 knots are wonderful things in that they really don't tend to bind up and become very difficult to untie. https://www.animatedknots.com/figure-8-knot

What length of the shoe laces do you use?