Frozen cum play questions
Posted: Mon May 26, 2014 12:14 am
Hi everyone,
I started collecting my cum. The goal is to accumulate at least 30ml of cum in no less than 2 week through ruined orgasms only. I will refrain all full orgasms for at least 2 week, but will continue as long as needed to get the 30ml. It represents about 6 X 5ml loads, which is about my average load after 2 days...
Each load is added to a small container that I put back in a real freezer (-30C). I get the container out after I edged a couple of times and do the "leaking part" close to the freezer so it gets back in it as quickly as possible after that.
My questions are:
- Will the melted cum keep its white, thick and sticky texture? Or will it turn into a watery slime like a load of cum that sits at room temperature for 15 minutes?
- What's the best way to melt the cum and bring it to body temperature for playing with it? The only thing that matters is I want the result to be as close as possible to real freshly ejaculated semen.
- Any other tips or tricks you learned for experience that worth sharing on the subject?
Also, I have some ideas of what to do with it... The goal is always to consume it... My preferred one being separating the monster load in 6, just like 6 normal loads and start masturbating at a predefined speed. When I reach the edge, I get a 1 minute break during which I have to drink 1 part of the load before starting again. After all the load is swallowed, orgasm is allowed and ejaculated cum will be stored for another two weeks of ruined orgasms and collecting the cum...
This could be a good routine to avoid having an orgasm too often (2 weeks minimum) while eating all the cum I ejaculate. With time, periods and amount of cum can be increased (40ml, 3 weeks, divided in 9 for consuming after 9 edges before the final orgasm)...
Awaiting your feedback!
Best regards,
I.
I started collecting my cum. The goal is to accumulate at least 30ml of cum in no less than 2 week through ruined orgasms only. I will refrain all full orgasms for at least 2 week, but will continue as long as needed to get the 30ml. It represents about 6 X 5ml loads, which is about my average load after 2 days...
Each load is added to a small container that I put back in a real freezer (-30C). I get the container out after I edged a couple of times and do the "leaking part" close to the freezer so it gets back in it as quickly as possible after that.
My questions are:
- Will the melted cum keep its white, thick and sticky texture? Or will it turn into a watery slime like a load of cum that sits at room temperature for 15 minutes?
- What's the best way to melt the cum and bring it to body temperature for playing with it? The only thing that matters is I want the result to be as close as possible to real freshly ejaculated semen.
- Any other tips or tricks you learned for experience that worth sharing on the subject?
Also, I have some ideas of what to do with it... The goal is always to consume it... My preferred one being separating the monster load in 6, just like 6 normal loads and start masturbating at a predefined speed. When I reach the edge, I get a 1 minute break during which I have to drink 1 part of the load before starting again. After all the load is swallowed, orgasm is allowed and ejaculated cum will be stored for another two weeks of ruined orgasms and collecting the cum...
This could be a good routine to avoid having an orgasm too often (2 weeks minimum) while eating all the cum I ejaculate. With time, periods and amount of cum can be increased (40ml, 3 weeks, divided in 9 for consuming after 9 edges before the final orgasm)...
Awaiting your feedback!
Best regards,
I.