Milovana.com

zebbg69 wrote: Mon Sep 27, 2021 7:59 am W
O M G !!!
W

BoundSquirrel wrote: Mon Sep 27, 2021 5:00 am The eStim file was breathtaking and a dream to get through.

The squirrel has it right!!

Spoiler: show

I thought I was done-for about 5 minutes in, but instead the e-stim track slammed me into a jaw-dropping hard edge and kept me there for most of the remaining play time, only interrupted by the "red light" periods. I had really given in, just thought I was going to hose all over and have to try again, but then to be TOYED with like that was delicious. That is the second time I have experienced this with e-stim, and both have been digitalparkinglot! The other was the recent Shibby one I think.

I had stimmed for a few hours beforehand. Not too intense, just pleasure and light edging. Maybe that's why this signal OWNED me so fast.

For wiring, I used my old favorite "split common" where I connect the tri-phase common to a pad behind the balls and join it to one pole of an anal plug, then channel B to the other pole of the anal plug and A to the cock head. On my BT-Stim device, I usually do this by throwing the "3/4" switch to "3" so that both black leads are connected internally, then I plug the "A" black into the balls pad and the "B" black into whichever pole of the anal plug I want, no Y-adapters needed.

Either anal pole as common creates a deep, satisfying pounding exquisitely complementing the cock action, but in different ways. Connecting the anal tip as common effectively makes a double-size common in the center, balls and prostate area all tied together as one zone feeding current out to the cock head and anal rim, which feel very strong and distinct because of their smaller size vs. the larger common. The other configuration splits the common out to the rim, flanking the active "B" channel in the prostate area. The "B" current splits in two directions, from the anal plug's tip "up" toward the balls and "down" toward the rim. Usually this is the configuration that does the harder, focused pounding, and it often even feels like it is twisting inside, but with this video's e-stim track, both configurations tended to do that in subtly different ways. I kept switching back and forth during the red light periods!

I haven't even mentioned the video. It was about the most visually yummy thing I have ever seen. These two scrumptious stars are to die for.

Well done and thank you, digitalparkinglot! This one's going on the All-time Best list.

Spoiler: show

aneros1_sm.jpg (291.95 KiB) Viewed 3534 times

aneros2_sm.jpg (297.71 KiB) Viewed 3534 times

• The construction is done with 1/4" or 6mm copper tape, smoothed out as best you can.
• The edges are sealed with clear nail polish.
• Nail polish is also used to insulate the lower visible half of the copper strip.
• Then it's mildly sanded with fine 400 grit wet or dry sandpaper to make sure there are no rough edges.
• It should feel completely smooth.
• I have some hot glue on the tabs to make them a little larger and more comfortable for me.