Page 4 of 6
Re: [RELEASE] [ESTIM] Clutch
Posted: Wed Mar 05, 2025 7:57 am
by Mixk
I also loved this. It is by far my favorite video and stim file combination. I really enjoy the longer set ups, it gives you enough time to get completely into it all without loosing interest.
satn00b wrote: Tue Feb 04, 2025 7:14 am
Also the "ruin" part was very nice. Quite different from any other stim I played. The only thing I would suggest is to make the cum section longer next time. I'm a person that can't cum "on the spot" if I held back for quite some time. But that may be only me in the end
I used wavepad and repeated the cum part once to the script and worked great for me.
I hope more of these are to come.
Re: [RELEASE] [ESTIM] Clutch
Posted: Mon Apr 07, 2025 11:48 am
by BobbyS
Electro wrote: Sun Feb 02, 2025 1:23 am
I think the best way to do what was just described is to put left channel + on cock head, left channel - on prostate side of anal plug. Right channel + on the opposite side of anal plug and right - at cock base(pick your fancy of bottom side of cock forward of the balls or perineum electrode, or ring at base of shaft with top insulated). I find I need to raise the right channel volume a bit to make it even between channels with this configuration, but it feels intense. I can't find another way to get the anal electrode ghost fucking while also keeping the perineum clench and the head electrodes all feeling great at the same time and the way this stim moves between channels with short burts of overlap has an interesting sensation.
Notice that what this is doing is putting one of the negatives and one of the positives on the anal plug. Also puts one of the positives and one of the negatives on the cock side. This way it's similar in some ways to having a bipolar plug on its own channel but also getting the interaction of anal to cock and anal to perineum that feels in some ways like the tri-phase sensation does. Some stim really doesn't feel great like this, but for this type of stim, it really does it for me.
I actually slightly miswired this.
Your setup:
L+ cockhead, L- prostate end of bipolar plug
R+ other end of plug, R- base (perineum}
What I did:
L+ cockhead, L- OTHER end of plug
R+ PROSTATE end of plug, R- base (perineum)
In other words, I got the plug contacts the wrong way round.
HOWEVER, having tried both versions, I STRONGLY recommend giving mine a go.
The default config puts too much power on the TENS pad I use on my perineum to be enjoyable.
Yours is better - though the right channel feels too weak.
This config I discovered by accident though? Completely changes the feel, to the point you could tell me it was designed for this.
You REALLY feel the prostate stim, to the point your attention is flicked back and forth between your cock being played with and your prostate being milked.
Seriously encourage everyone to give this config a go
Re: [RELEASE] [ESTIM] Clutch
Posted: Mon Apr 07, 2025 6:41 pm
by Electro
It's weird because that configuration is what I first tried and that made one of the channels very weak when trying it with Restim(and a very different calibration than normal in either separately calibrated configuration). I'll play around and try it that way with Clutch, good that you pointed it out.
Re: [RELEASE] [ESTIM] Clutch
Posted: Mon Apr 07, 2025 6:46 pm
by BobbyS
How intriguing.
Just to be sure we're on the same page: I'm taking "other end" of the bipolar plug to mean the far end (nearest the cable sockets) that rests against and stimulates your anal sphincter?
Your response suggests we both have one way of doing it that results in a weak channel and the other way round doesn't - only they're inverted between us. Which makes me wonder if I've fundamentally misunderstood the wiring...
Re: [RELEASE] [ESTIM] Clutch
Posted: Mon Apr 07, 2025 7:00 pm
by Electro
BobbyS wrote: Mon Apr 07, 2025 6:46 pm
How intriguing.
Just to be sure we're on the same page: I'm taking "other end" of the bipolar plug to mean the far end (nearest the cable sockets) that rests against and stimulates your anal sphincter?
Your response suggests we both have one way of doing it that results in a weak channel and the other way round doesn't - only they're inverted between us. Which makes me wonder if I've fundamentally misunderstood the wiring...
Not quite, usually when I go dual channel, I'm using one of these smaller probes where I point one side at the prostate and the other side towards the 'butt side'. See picture, one of these metal electrodes points at prostate. So this could be a very different nerve trigger mechanism with yours probably being ideal compared to mine.
Sort of unrelated but I feel like I need to say this because my electrodes are different. For my other larger plugs FLP 40 or Moaner style, I usually just use the one internal electrode that's near the tip but that's because mine are homemade clones and I haven't got the base electrode to feel right because of my own limitations to manufacturing an electrode on a curve with multiple dimensions versus just a 'wrap around the cylinder' electrode, which doesn't have enough surface area on the narrow flat part to feel good with the level of power I need at the tip to get the right muscle action.
Re: [RELEASE] [ESTIM] Clutch
Posted: Mon Apr 07, 2025 7:05 pm
by BobbyS
Ahhh. That'll explain it.
I normally don't like using the sphincter contact as it can be too much. But with this config it works just right.
I used to use electrodes like the one pictured, but my muscle contractions when stimming would pull it deeper inside, past the flared base. Aside from the safety implications of that, it also led to some very unpleasant sensations when the rear contact got too close to the spine.
Re: [RELEASE] [ESTIM] Clutch
Posted: Mon Apr 07, 2025 7:24 pm
by Electro
BobbyS wrote: Mon Apr 07, 2025 7:05 pm
Ahhh. That'll explain it.
I normally don't like using the sphincter contact as it can be too much. But with this config it works just right.
I used to use electrodes like the one pictured, but my muscle contractions when stimming would pull it deeper inside, past the flared base. Aside from the safety implications of that, it also led to some very unpleasant sensations when the rear contact got too close to the spine.
I've come across some other versions similar to what I have that seem to have a slightly smaller base, I guess it hasn't been an issue for me but then again if it found it's way in its not bigger than a size I could fish fingers inside and grip the base and pull if it happened, at least for me.
In any case, I wired up to your configuration and swapped it between that and the one I originally suggested, with my electrodes I'm not noticing a huge difference between the two(at least not like with Restim) but it seems your suggested configuration does give the stronger prostate feel which makes sense since the base and prostate are on the same channel. Either way I'm boosting the right channel volume to balance things out when wiring like this.
Re: [RELEASE] [ESTIM] Clutch
Posted: Mon Apr 07, 2025 10:59 pm
by samsonjude1776
Electro wrote: Mon Apr 07, 2025 6:41 pm
It's weird because that configuration is what I first tried and that made one of the channels very weak when trying it with Restim(and a very different calibration than normal in either separately calibrated configuration). I'll play around and try it that way with Clutch, good that you pointed it out.
When you say you are trying it through Restim, what do you mean? Are there funscripts for this file?
Re: [RELEASE] [ESTIM] Clutch
Posted: Tue Apr 08, 2025 1:04 am
by Electro
samsonjude1776 wrote: Mon Apr 07, 2025 10:59 pm
Electro wrote: Mon Apr 07, 2025 6:41 pm
It's weird because that configuration is what I first tried and that made one of the channels very weak when trying it with Restim(and a very different calibration than normal in either separately calibrated configuration). I'll play around and try it that way with Clutch, good that you pointed it out.
When you say you are trying it through Restim, what do you mean? Are there funscripts for this file?
No funscripts for Clutch unless someone makes them. I meant trying the electrode configuration I was talking about with Restim using funscripts with a different video. That's where I thought to try wiring my unusual electrode configuration for this video.
Re: [RELEASE] [ESTIM] Clutch
Posted: Thu Apr 10, 2025 11:15 am
by edger477
Re: [RELEASE] [ESTIM] Clutch
Posted: Sat Apr 19, 2025 10:36 am
by diglet
I created restim funscripts for this masterpiece, you can download here:
https://mega.nz/folder/JPVVCboa#JEjMGNmciaJt8f_77EpeHg
Settings:
pulse frequency 0-100 (the default)
pulse width 3-20
I had to take minor creative liberties:
* The original caps at 120hz pulse frequency, but I lowered it to 100hz because that's the programmed limit for the FOC. And everything above 60-80hz feels the same to me anyway.
* The 'pulses between pulses' stuff that adds extra intensity to the R electrode could not be reproduced. I opted to split the tracks, the funscripts contain the 'main' track. There is one additional funscript, Clutch.unconverted.funscript, that contains the intensity of the unconverted stuff. This script is unused.
You probably won't notice anything is missing.
It is possible to mix the main track and the unconverted portion, using some math I still need to invent. But I opted not to do this because I stim with only external electrodes, and the unconverted portion is clearly intended to add extra spice for internal electrodes.
I tested it once, I think I managed to hit every single edge. It's good.
Re: [RELEASE] [ESTIM] Clutch
Posted: Sun Apr 20, 2025 1:29 pm
by Pinco
great conversion!!! I liked a lot!! Thanks for your effort.
BTW I noticed that if you play a video without a volume.funscript after one with volume.funscript the tcode/funscript volume doesn't get to 100% as it should but varies randomly. So to play correctly videos without volume.funscript you need to restart restim.
Re: [RELEASE] [ESTIM] Clutch
Posted: Sun Apr 20, 2025 3:40 pm
by diglet
Pinco wrote: Sun Apr 20, 2025 1:29 pm
BTW I noticed that if you play a video without a volume.funscript after one with volume.funscript the tcode/funscript volume doesn't get to 100% as it should but varies randomly. So to play correctly videos without volume.funscript you need to restart restim.
This is a new bug added in the latest release. I already fixed it, but have not created a new release with the fix yet.
Re: [RELEASE] [ESTIM] Clutch
Posted: Tue Apr 22, 2025 11:47 am
by Pinco
diglet wrote: Sun Apr 20, 2025 3:40 pm
This is a new bug added in the latest release. I already fixed it, but have not created a new release with the fix yet.
hi, the last version works fine, thanks.
In your conversion pulse rise time is not present, which value are you using?
Re: [RELEASE] [ESTIM] Clutch
Posted: Tue Apr 22, 2025 1:23 pm
by diglet
I use a value of 3, but I don't think it matters too much which value you use.